Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

5 Control Heads Single Function - Dual Engine Controls Shift With the system OFF (no power on the CAN Bus) press and hold the NEUTRAL button on the CP1200 control panel and turn the power ON. The port neutral lamp will blink. Move the Port shift lever to the FORWARD position. The port neutral lamp will blink. Press the SELECT button. The select lamp will turn on. Move the Port shift lever to the NEUTRAL position. The port neutral lamp will blink. Press the SELECT button. The select lamp will turn on. Move the Port shift lever to the REVERSE position. The port neutral lamp will blink. Press the SELECT button.

The select and port neutral lamps will both blink indicating the process is complete. Turn the power OFF to exit the port calibration process. Move the Starboard shift lever to the FORWARD position. The starboard neutral lamp will blink. Press the SYNC button. The sync lamp will turn on. Move the Starboard shift lever to the NEUTRAL position. The starboard neutral lamp will blink. Press the SYNC button. The sync lamp will turn on. Move the Starboard shift lever to the REVERSE position. The starboard neutral lamp will blink. Press the SYNC button. The sync and starboard neutral lamps will both blink indicating the process is complete.

Turn the power OFF to exit the starboard calibration process. Throttle Note: Move the CP1200 Control Panel Connector to the CE41600 Harness Throttle Connector Turn system power off before connecting CP1200 panel to the CE41600 Throttle Harness. With the system power off (no power on the CAN Bus) press and hold the Neutral button on the CP1200 Control Panel and turn the power ON. The Neutral Lamp will blink. Move the Port throttle lever to the FULL THROTTLE (WOT) position and press the SELECT button. The select lamp will turn on. Move the Port throttle lever to the IDLE position. The port neutral lamp will blink. Press the SELECT button. The select lamp will turn on.

Move the Starboard throttle lever to the FULL THROTTLE position and press the SYNC button. The sync lamp will turn on. Move the Starboard throttle lever to the IDLE position. The starboard neutral lamp will blink. Press the SYNC button. The sync lamp will turn on. When complete, return the CP1200 connector to the CE41600 Operator’s Panel Connector. © 2011 Yanmar Marine International • Rev. 2.0 5:30 Yanmar Electronic Control Systems Technical Manual