Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

6 Interface Modules BY, BY2 unlimited i8150 New Features The trim-signal from MerCruiser BRAVO or the ZT350 Smartstick® can be connected and read on CAN Bus gauge or display. Works with i5601-V4.01 display for calibration of trim sender. Improved trolling software V1.01 implemented for smoother trolling modulation. Transmission Neutral Start Protect Transmission Neutral Start Protect is an active low, discrete switch input to Vbat Return. It is pulled up internally to +5 VDC through a 10KΩ resistor. Range: Ground, 5 VDC Signal Name: Neutral Start Outputs Shift A/ Shift B Shift 1 and Shift 2 are high side discrete outputs. Rating: 50V, 2 Amp Range: Open, Battery + Signal Name:

Shift A, Shift B. Trolling Valve Trolling Valve is a pulse width modulated high side discrete output. Rating: 50V, 2 Amp Range: Open, Battery + Signal Name: Troll Alarm Alarm is an electronic switch to V Batt Return. Rating: 62V, 1 Amp Range: Ground, Battery + Signal Name: Alarm i8130/40/50 Fuel Sender Connections The i8130/40/50 Engine Interface box can handle two fuel senders. The sender inputs are both two- wire inputs and may be used for single or double pole fuel sender applications. When used for single pole application the return line is connected to ground, preferably at the tank. When set for US calibration the range of both senders is 33 (full) to 240 (empty) ohms.

When set for European Calibration the range of both senders is 180 (full) to 10 (empty) ohms. The units are shipped set for European Calibration. To change to US calibration, cut the black wire going into pin G1 of the J2 connector on the i8130/40/50 module. The fuel sender wires are available in the CE50206 Harness near the i8130/40 module connector. The Fuel 1 Sender wire is pink with a white tracer. The Fuel 2 Sender wire is pink. Both Fuel Return wires are black. For the proper “Instance” numbers see “Section 4 - Gauges” or “Section 8 - Networks” in this manual. i8130/40/50 Paddle Wheel Connections The i8130/40/50 Engine Interface box has three wires to connect the paddle wheel.

The Paddle Wheel Reference wire is violet. The Paddle Wheel Signal wire is violet with a white tracer. And the Ground wire is black. These wires are found in the CE50206 cable near the connector to the i8130/40/50. © 2011 Yanmar Marine International • Rev. 2.0 6:4 Yanmar Electronic Control Systems Technical Manual