Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

6 Interface Modules BY2 unlimited BY2 Unlimited Series Engines - i8150 interface* * replaces i8130 and 8140 models used by BY Unlimited Series Engines Port or Single Unit • Fuel level input 1 - K2 data instance 0 • Fuel level input 2 - J2 data instance 2 Starboard Unit • Fuel level input 1 - K2 data instance 1 • Fuel level input 2 - J2 data instance 3 Note 1 - J1939 is output only Note 2 - Paddle wheel frequency is 19000 pulses per nautical mile. Specifications Operating Temperature: -18°C (0°F) to +70°C (+158°F). Storage Temperature: -40°C (-40°F) to +80°C (+176°F). Electrical Connection: All interconnects to the i8130/40 Engine Interface are accomplished with integral connectors.

See Table for pin out information. Fuel Level is an analog input from a fuel level transducer. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 6:3 A1 Battery Gnd Terminal A2 Check Engine Lamp A3 Battery Positive Terminal B1 Shift A B2 Shift B B3 Trolling C1 Power “+” (NMEA NET S) _ C2 CAN High (NMEA NET H) _ C3 J1939 Hi (Note 1) D1 Return/Shield (NMEA NET C/SHIELD) _ D2 CAN Low (NMEA NET L) _ D3 J1939 Lo (Note 1) E1 Return/Shield (NMEA NET C/SHIELD) _ E2 Check Engine (EMS) E3 J1939 Shield F1 Paddle Wheel Signal (Note 2) G1 US/EUR H1 Gear Lube H3 Gnd J1 Water In Fuel Filter J2 Fuel 2 J3 Oil Pressure Sensor K1 Ignition Power K2 Fuel 1 K3 Trim