Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

section 8 networks Yanmar electronic engines use several networks to communicate a variety of information. The networks carry digital signals that report various data about the engine and instruct the engine and some of its accessories on what actions to perform. These signals can start or stop an engine or change the throttle setting. They also report the status of the engine and any alarms or diagnostics that may occur. There are many types of networks. Some are developed by a company and used only by that company. These are closed networks and the company that sets up the network completely controls the network. Others are industry standard networks that are used by many companies.

If many companies use an industry standard network and an industry organization or specific company makes that network available to all at a very low or no cost the network is referred to as an open network. This type of network has the advantage of having many companies provide equipment in a competitive fashion thus benefiting the end user. The Internet is probably the best known open network. Yanmar uses open industry standard networks with its engines as these best serve the customer. There are three types of networks used with Yanmar electronic engines.

A CAN (Control Area Network) Bus network is used to handle all of the communication between the engine and the controls, displays and gauges. This is a moderate speed robust network that allows a number of products from many manufacturers to communicate a variety of information. The second network is a smaller network used on the BY2 series of engines for diagnostics. The third network is used on the serial gauges. All networks require a set of rules to operate. These rules are called the network protocol. On open networks they are usually developed by industry groups to meet the specific needs of that industry. The protocols used with the Yanmar engines are as follows.

J1939 is a CAN Bus standard developed and used by the automobile industry. It is used on the 6LY3, 6CX and SY GEN III for on-engine communications and for engine-to-engine interface module communications. J1708 is a low performance network used within the serial gauge system between the tachometer and the other gauges. NMEA 2000 ® is an enhanced version of the J1939 protocol developed by the National Marine Electronics Association to serve as a robust standard for the marine industry. It is used on all Yanmar Electronic Control Systems. OBD-2 Protocol is used on the BY2 series of engines to communicate diagnostics.

This protocol was developed by the automobile industry and the use of this protocol on the BY2 series allows the use of some standard automobile diagnostic tools. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 8:1