8 Networks NMEA 2000 ® Introduction The National Marine Electronics Association (NMEA) is a non-profit organization of Marine Electronic Dealers and Manufacturers located in North America. Over the years they have supplied a number of valuable services to help and promote the marine industry. One of those services has been the development of open industry protocols for digital communications between various pieces of electronic equipment on boats. The most widely used protocol currently in use in the marine industry is one of their standards known as NMEA 0183.
This protocol allows the connection of a few pieces of gear and the sharing of a limited amount of information digitally at what today would be called slow speeds. It has and continues to serve the industry well in this type of application. In the early 1990s, the NMEA saw the need to develop a next generation protocol that would permit a larger number of devices to work together on a network at higher speeds. Working with a number of companies and the United States Coast Guard a new protocol was developed and released in 2001.
That protocol is referred to as NMEA 2000 ® and the designation is a registered trademark of the National Marine Electronics Association Understanding - NMEA 0183 networks and NMEA 2000 ® networks will not work together. The protocols are completely different and a converter box is required to connect any devices between the two different networks. The NMEA 2000 ® protocol used the SAE (Society of Automotive Engineers) J1939 protocol as its starting point. This allowed the use of the components from the auto industry in the design of the hardware, assuring wide parts availability and lower component cost.
There are some key application differences between the two industries so a separate standard was required for marine. Some of those differences are listed here to make it easier to understand the reason for a separate protocol. Most vehicles have all of their equipment installed and setup up by the vehicle manufacturer. In the boating world equipment is regularly installed at the factory, but also at the distributor, dealer, and by the end user. The NMEA group that developed the NMEA 2000 ® protocol wanted to be able to connect and disconnect equipment from an operating network with no loss of data or security.
This would help in troubleshooting and reduce the possibility of an end user having a problem. The NMEA group that developed the NMEA 2000 ® protocol also wanted a network that would allow mission critical control signals (safety related) and a mix of all other types of data to use the same network without impacting the safety of the vessel. True “plug and play” interconnection of equipment was an important goal, so no customized setup would be required for each installation. All of these goals and many others were achieved in the resulting NMEA 2000 ® protocol. The NMEA is the controlling body for the protocol and offers it to all companies at a modest price.
The protocol specifies that to use the NMEA 2000 ® mark on a product the user must follow all aspects of the protocol which include testing of the product to assure its compliance with the protocol. Understanding - Because of the details in the protocol and the testing specified by the standard, when two NMEA 2000 ® devices are plugged onto the network they startup and operate without any Setup. © 2011 Yanmar Marine International • Rev. 2.0 8:2 Yanmar Electronic Control Systems Technical Manual