8 Networks Network Basics The transmission of a message as defined by the NMEA 2000 ® protocol is quite technical and outside the scope of this document. Complete information may be obtained from the NMEA on the web at www.nmea.org. They have the necessary support literature such as the NMEA 2000 ® documentation, and a NMEA 2000 ® developers group. Below is a much less detailed technical overview of the message transmission. Those interested in only the most general details should skip to the “4. Application Layer” section. Data on a NMEA 2000 ® network is processed very much like data on a J1939 network and like the J1939 protocol the NMEA 2000 ® protocol defines four layers. 1.
Physical Layer 2. Data Link Layer 3. Network Layer 4. Application Layer 1. Physical Layer The network uses two twisted pair wires, one pair is for data communications and the other is for power distribution. A device may or may not use power from the network, however it will use the common reference. Shielding was very carefully considered in the protocol and involves the individual shielding of the data wires, power wires, and an overall shield. The Data Pair is a two wire twisted pair that forms a balanced differential circuit. Devices connected to the data pair receive and transmit data over those wires. The data pair forms a data transmission bus through the network.
The bus is terminated at each end with a 120 ohm resistance. Each device connects to the wires by means of “T” connections along the bus. The 120 ohm termination at each end of the bus eliminates signal reflections that would interfere with data reception. The Power Pair is another two wire twisted pair that provides power to devices that require power from the network. Any device can take a maximum of 1 amp from the bus. However, the total power used must be checked by the system designers (see “Powering the Bus” on page 8:10). This power requirement is specified by the manufacturer as a LEN (Load Equivalency Number where 1 LEN = 50mAmps).
A more detailed discussion of CAN Bus power is covered later in this section. The cable consists of two twisted pairs and a shield connection. Each twisted pair is shielded and the overall cable is shielded. One pair is the CAN Bus signals referred to as CAN Hi (white) and CAN Lo © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 8:3 Name Color Pin # Application Shield Bare Pin 1 Power V+ Red Pin 2 12 Volt DC Plus Power V– Black Pin 3 12 Volt DC Negative CAN Hi White Pin 4 Signal CAN Lo Blue Pin 5 Signal