Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

8 Networks Specifications All devices on the NMEA 2000 ® CAN Bus are equal; there are no special controlling devices. Therefore any two NMEA 2000 ® devices may be connected to form a network. The actual connections are shown later in this section. The general specifications for a NMEA 2000 ® Micro C networks are: Up to 50 physical connections known as nodes may be used on a network. The network speed or Baud Rate is 250kbits/second. The main backbone length can be up to 100 meters. Long length may affect signal quality and power supply may be limited due to voltage drops (IR losses). Drop Length, maximum:

6 meters - however many manufacturers recommend this to be as short as possible - typically less than two meters. The total drop length of all drop cables should be less than 78 meters. The “T” connectors can be stacked together. Each network needs 2 and only 2 terminators. Total current draw should not exceed 4 amps. Basic Network The NMEA 2000 ® protocol allows several types of cable. The one shown in this document is the smaller type used in pleasure boats and small vessels. The larger cable is used in shipboard applications. Any manufacturer may use their own cables but to adhere to the standard they must have an adaptor cable that allows easy connection to the approved cables.

All Yanmar CAN Bus cables meet the NMEA 2000 ® standard and will work with any other suppliers’ cables that meet the NMEA 2000 ® standard. While the NMEA 2000 ® standard allows separate wires and terminals all Yanmar CAN Bus cables use the connectors shown in this manual. They are easy to install and result in a high quality, rugged, waterproof installation. The cables should never be cut and spliced. Male Terminator A typical NMEA 2000 ® cable Female Terminator CM100XX: A typical NMEA 2000 ® cable CM100XX where “XX” equals the length of feet. See “Section 17 – Spare Parts” for part numbers. © 2011 Yanmar Marine International • Rev.

2.0 8:8 Yanmar Electronic Control Systems Technical Manual “T” co nnector