8 Networks CM10051: Male Terminator CM10052: Female Terminator “T” Connectors: Supplied by several vendors. Appearance may vary - parts are interchangeable. CM10060: Single “T” Connector CM10064: Four “T” Connector Backbone Male Backbone Female Male Female NODE is always Female NODES are always Female Not Yanmar supplied Note regarding connectivity of “T” Connectors: When connecting a “T” connector to a component always install via the middle connection (“NODE”). When connecting a “T” connector to a CAN Bus cable to connect components that are far from each other, always install via the male/female end of the connector (whichever applies). Hand-tighten after the connection is made.
Do not tightly tie down the “T” connectors, as this will create stress. The Network must consists of a single cable run to which devices are connected by means of a “T” Connector. All products must connect onto the node part of the “T” connector. Each end of the cable must have a terminator. It is essential there be a total of two, and only two, terminators - one located at each end of the backbone. Understanding - a “T” connector with nothing attached to its node is OK and will not effect the network. NEVER use a terminator to cap the node of an unused “T” connector. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 8:9