Abbreviations The following abbreviations are used in this manual: ABYC American Boat & Yacht Council AUX Auxiliary AWG American Wire Gauge Bar Barometric BAT Battery CAN Control Area Network CBCH CAN Bus Control Head CAN Bus Control Area Network (data) bus.
(A cable of wires that carry digital signals and power between electronic modules) Cels Celsius COG Course Over Ground ECU Electronic Control Unit EIM Engine Interface Module ENG Engine Fah Fahrenheit Gal Gallon GND Ground GPS Global Positioning System INFO Information LED Light Emitting Diode Ltr Liter (Litre) KHz Kilohertz Km/h Kilometers Per Hour kPa Kilopascal (0.0102 kg/ sq cm) mA or mAmp Milliamp (1/1000 of an ampere) MAG Magnetic MPH Miles Per Hour M/S Meters Per Second NMEA National Maritime Electronics Association NMEA 2000 ® The special protocol for digital communication on a CAN Bus Nm Nautical Miles NSP Neutral Start Protection N/C No Connection PGN Parameter Group Number PSI Pounds Per Square Inch RPM Revolutions Per Minute SIM Subsystem Interface Module SOG Speed Over Ground SOW Speed Over Water STBD Starboard (right) SW Switch VMG Velocity Made Good WOT Wide Open Throttle XTE Cross Track Error Note:
Some abbreviations not listed here may be found in their respective sections. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual xxiii