revision History REVISION HISTORY This manual is a living document. Periodic manual revisions are published to document product improvements and changes. This practice ensures the manual has the most current information. As manual revisions become necessary, individual pages will be prepared and sent to those who need the information. If a page, or number of pages should be replaced, the replacement information will be sent along with a revised Revision Control Table. Discard the older, obsolete information. Revision Control Table At times, the revision involves inserting additional pages in one or more sections. Insert the new information and a new copy of the Revision Control Table.
This method of revision control represents the most cost-effective solution to providing fresh, updated information as needed. © 2011 Yanmar Marine International • Rev. 2.0 xxiv Yanmar Electronic Control Systems Technical Manual Revision Date Revision Number Page Numbers Involved Remarks Initiating Department Oct. 10, 2010 - Rev.
1.06 Cover New - Additional engines listed; revision level update Sales All Copyright date Sales Throughout Update and Inclusion of BY2 Series Engines Engineering Throughout Update and Inclusion of 6CX Series Engines Engineering iii - xvii Update of Table of Contents Engineering xix Update information Engineering xxvi - xxviii Update revision table Engineering 1:2 Remove Tach part number, update image.
Add part numbers to Key Switch Panel Kit Engineering 1:4 Remove Tach and Speedo part numbers, update Tach image; update i8150 EIM information Engineering 1:5 Update i8125 EIM information Engineering 1:6 Update i8355 EIM information Engineering 1:8 Addition of CH8000 Engineering 1:9 Addition of CE67603 Engineering 1:12 Update Electrical Harness information Engineering 2:2 Update BY2U, 6LY3 and 6CX EIM information New features for i8150 Engineering 2:4 Update BY2U gauge part number Engineering 2:5 Addition of Start/Stop Panels Engineering 3:1 Inlcusion of 6CX “default monitor” caution; software revision level Engineering 3:2, 3:3 Update software revision level information Engineering 3:11, 3:12 Update chart information/software revision level Engineering 3:13, 3:14 i5601E - Selecting 6CX engine type Engineering 3:15 Update software revision level Engineering