9 Connectivity 6LY3, 6CX 6LY3 and 6CX SERIES ENGINES Note: Early 6LY3 Engines use a CE415XX Engine Harness while later units, inlcuding 6CX Engines, use a CE425XX Engine Harness. Separate diagrams are shown in this section for each engine harness type. 6LY3 Power Diagram Outline Make all connections per ABYC standards. Make the following battery connections ONLY if you have successfully completed all prior steps. Engine or system damage could occur. NOTICE 1. Battery positive to starter. This connection is normally made through the battery switch. The gauge of the wire depends on the length of the cable (see image below). 2. Battery negative to engine block.
The gauge of the wire depends on the length of the cable. 3. Connect the red wire from the engine ECU to the bat+ using a switch and fuse or breaker. 4. Connect the black wire to the battery negative. 5. A detailed power diagram appears later in this section. 2 Note: Should be easily accessible for shut down * Fuse is not required if there is a breaker in battery area 1 On multi-engine installations, connect engine blocks to each other using wire that is equal to or heavier than the battery cable. Note: For fuel level, alarms, annunciator, etc., see “Section 16 - Accessories.” © 2011 Yanmar Marine International • Rev. 2.0 9:16 Yanmar Electronic Control Systems Technical Manual