9 Connectivity 6CX 6CX Power Diagram Outline Note: The 6CX engine covered in this book is the electronic version identified as 6CX530. Make all connections per ABYC standards. NOTICE Make the following battery connections ONLY if you have successfully completed all prior steps. Engine or system damage could occur. 1. Connect battery negative to engine block. The gauge of the wire depends on the length of the cable. 2. Connect the heavy red wire from the engine ECU to the bat+ (positive) using a switch and fuse or breaker. 3. Connect the small red wire with the fuse to the bat+ (positive). 4. Connect the black wire to the battery negative. 5. Battery positive to starter.
This connection is normally made through the battery switch. The gauge of the wire depends on the length of the cable (see image below). 6. A detailed power diagram appears later in this section. 3 2 4 1 Note: Should be easily accessible for shut down * Fuse is not required if there is a breaker in battery area 5 On multi-engine installations, connect engine blocks to each other using wire that is equal to or heavier than the battery cable. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 9:17