15 Troubleshooting DIAGRAM 1 Typical CAN Bus Starting Point Reduce Bus Terminator A CB Control Head Gauges Stbd Gauges Port i5600 Display Stbd Helm Step 1 Reduce Bus Disconnect GPS & Pilot. including “T” Connectors. Reconnect remaining “T”s. This may require the use of another CAN Bus cable. i5600 Display Port GPS Autopilot Battery Engine Interface Port Engine Room Engine Interface Stbd Terminator B Step 2 Reduce Bus Remove tower by shortening the Bus. Move the terminator or use a spare terminator. Battery Tower CB Control Head i5600 Display © 2011 Yanmar Marine International • Rev.
2.0 15:8 Yanmar Electronic Control Systems Technical Manual Terminator A CB Control Head Gauges Stbd Gauges Port i5600 Display Stbd i5600 Display Port GPS Autopilot Battery Engine Interface Port Engine Interface Stbd Battery CB Control Head i5600 Display Terminator B