15 Troubleshooting Network Status Display The Network Status Display Screen shows details of the NMEA 2000 ® Network and allow determination of Network Problems. (The values are constantly monitored and do not rely on the screen being displayed.) Bus Load: Current bus load over 1 sec Peak Load: Peak Load since last Reset or “Power On” Frames/Sec: Current frames transferred over 1 sec Total Frames: Total number of frames since last Reset or “Power On” Error Frames/Sec: Error frames over 1 sec Errors Total: Total Number of errors since last Reset or “Power On” Bus Off If YES, indicates unit is not Transmitting on Bus Bus Voltage: Measured Value of Bus Supply Buttons:
“Back” - Moves back to previous menu “Reset” - Resets the various parameters that have accumulated values Understanding – The following are typical key readings: • Bus Load 1 – 20% • Error Frames per Second Less than 5 for any short time and 0 or 1 on any longer term basis • Total Errors Less than 10 one minute after startup • Voltage 10 – 15 volts with 12 – 14 being typical • A high bus load (above 25%) indicates some item on the bus is causing a problem or there is a cable or connector failure. • High error rates usually indicate a cable problem. • Very high error rates usually indicate a cabling or terminator issue.
Tracking and Troubleshooting CAN Bus Issues When “T” connectors are connected together and tied down very tightly, the pressure can cause them to fail. If connectors are tied very tightly and appear to be curved or stressed, this is a potential failure location. CAUTION All CAN Bus problems are addressed with a common technique. Reduce the size of the CAN Bus and isolate the defective component. Use the diagrams on the next few pages to understand the process, and then apply it to your system. After each step, reset the system and recheck Network Status Screen data. For this process it is convenient to have an extra pair of terminators and some spare CAN Bus cables and “T” connectors.
There is no special order to the various tries. Keep reducing the number of items on the CAN Bus and replacing the parts until the defective item is found. The data on the network status screen will tell the story. The errors will disappear or the bus load will return to normal. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 15:7