15 Troubleshooting CAN Bus Check and Diagnostics The i5601E, with software revision 3.0 or higher, is a good tool to check and diagnose CAN Bus problems in the Yanmar electronic control system. General operation of the digital display is covered in the i5601E Section of this manual. The network Status and Network Nodes screens are used in troubleshooting. However, before starting into the operation details, check the physical CAN Bus layout and observe what devices might be connected to the CAN Bus. General information on the Network Status screen and the Network Nodes screen is covered in “Section 8 - Networks” in this manual.
The system can show complete details, but a general network understanding is a good starting point. Turn ON the CAN Bus and observe the i5601E display. 1. If the Display and other CAN Bus devices do not come ON: refer to “Power” later in this section. 2. If the Display does not turn ON but other CAN Bus devices do: check cable connections, including the “T” connector, to i5601E. If the cable connections are good, replace i5601E. 3. If the Display turns ON: Using the menu structure detailed in “Section 3 - i5601E Digital Display”, go to the Network Status screen and observe the data.
While the CAN Bus will operate as low as 9 volts, any voltage below 12 volts indicates a likely problem which should be checked. It is advisable to check the power at several physical locations along the CAN Bus and especially at each end. If the CAN Bus power is correct along the CAN Bus you can start to look at the CAN Bus data information. If the power is not between 12 and 14 VDC (Volts Direct Current) it needs to be corrected before any meaningful data issues can be addressed. See “Power” later in this section. If the voltage is in spec, proceed with the data checks in the next section. © 2011 Yanmar Marine International • Rev. 2.0 15:6 Yanmar Electronic Control Systems Technical Manual