Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

15 Troubleshooting DIAGRAM 3 Reduce Bus Reduce Bus Terminator A Terminator A CB Control Head CB Control Head Step 5 Remove extra Power feed Reconnect “T”s. Step 6 Replace Cables. Gauges Stbd Gauges Stbd Gauges Port Gauges Port i5600 Display Stbd Always remove round gauges before removing extra power feed.

i5600 Display Stbd i5600 Display Port i5600 Display Port GPS GPS Autopilot Autopilot Battery Temporary Cable Battery Engine Interface Port Engine Interface Port Engine Interface Stbd Engine Interface Stbd Terminator B Terminator B Battery Battery CB Control Head CB Control Head i5600 Display i5600 Display After the defective item is found, reconnect the items that did not fix the problem a few at a time and monitor that the problem does not return. This assures that not more than one item was causing the problem. Keep in mind what items are powering the CAN Bus as you need to retain power and you must always have the two and only two terminators on the CAN Bus.

© 2011 Yanmar Marine International • Rev. 2.0 15:10 Yanmar Electronic Control Systems Technical Manual