Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

15 Troubleshooting Network Nodes Display The Network Units Display Screen shows Yanmar and Teleflex units that have claimed an address on the bus. From the information in the claimed message name (Device Class, Function, and Instance Fields) the type and model number of the unit will be determined. (The specific model may not be indicated, but it will give a general model of the type of the unit, e.g. i832x.) The information displayed consists of: Node Address Manufacturer’s Code - (All mfg’s codes will be shown, but only Yanmar and Teleflex units will show the mfg’s name) Manufacturer’s Model Info - On some units the ending letter signifies the following:

P - Port S - Starboard C - Center Engine Buttons: “Down” Arrow moves menu selection down. “Up” Arrow moves menu selection up. “Info” supplies expanded information (see note below). “Back” moves back to previous menu. Note: In version 4.0 software and higher additional informaiton about a node can be found by pressing the “info” button. The screen will display all devices on the CAN Bus that have claimed an address. Check that the number of devices actually on the CAN Bus match the number of physical devices on the boat. This will assure that all devices are really communicating on the CAN Bus. The NMEA website, www.nmea.org, lists the various manufacturers’ codes.

Power The Yanmar Electronic Control system uses engine battery power for most devices. The battery power is also supplied to the CAN Bus as its source of power. Devices that are on the CAN Bus and draw less than one amp take their power directly from the CAN Bus. This includes devices like control heads, digital displays, and gauges. Engine Interface units and actuators typically get their power from the engine battery. Other devices on the CAN Bus get their power from either the CAN Bus or the engine battery depending on their current draw and isolation. For additional information about CAN Bus power see “Section 8 - Networks” in this manual.

Table 5 will help locate a power problem (see next page). © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 15:11