15 Troubleshooting On multi-engine applications, each engine supplies power to the CAN Bus. Note: For fuse locations, see next page. © 2011 Yanmar Marine International • Rev. 2.0 15:12 Yanmar Electronic Control Systems Technical Manual TABLE 5 - Power Problems Problem Check Action No Control System power • Battery • Engine Breakers • Key Switch • Switch Panel Fuse • Fire System • Charge or replace • Reset or turn ON • Turn ON • Check fuse behind switch panel • Fire System must be operational for engine to run No CAN Bus power • Check battery power to Engine Interface. • BY2 Engines - check fuse F1, inside the E-box.
• 6LY3, 6CX Engines - check Fuse 1 in the fuse box • SY Gen III Engines- center breaker inside i8350. • Engine Interface • 3 Amp • Aux Power 10 Amp • NMEA Power 8 Amp Breaker • Check for other sources of CAN Bus power. They may have seperate fuses or diodes. No i5601E Display Power • Unit has power and contrast is set too low. • No power. • Increase contrast • Defective cable or “T” connector from CAN Bus No power at the control head • System ON and no control head lights. • Press select button on head. If green LED flashes head has power see CAN Bus check above. • If there is NO flash see “No CAN Bus power” section of this table.
No Second Station operation Switch Panel Fuse Check fuse behind Switch Panel. i8350 SY GEN III • No panel power • No EMS power • No EIM power • No EMS Key ON power • Breaker 10 Amp • Breaker 8 Amp • Breaker 8 Amp • Breaker 10 Amp • Power to Key Switch • Engine control power - ON/OFF with Battery Switch • Power to i8350 • Power to engine control when Key ON