Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

15 Troubleshooting Fuse Locations Most controls system fuses are found in the following locations: BY2 Engines - Inside the E-Box on the port side of the engine. 6LY3 Engines - Starboard side of engine, near the front. 6CX Engines - Starboard forward area. SY GEN III Engines - Inside the i8350 engine interface. ALL - Behind the Key Switch Panel. On a 6CX Engine - the i5601Es switch to 6LY3. The 6CX Engine Inteface Module is the same and the 6LY3 Interface Module. On any i5601E complete reset, the i5601E will revert to its factory setting of 6LY3. Follow the instructions in Section 3 - i5601E Digital Display, page 3:13 to convert back to 6CX.

Individual Component Problems Control Head Alarms Critical Alarms Continuous flashing of both lights on either side of the control indicates a Critical Alarm. System will do a “Safe Shut Down,” and must be serviced before further use. When a critical alarm occurs, the system will automatically go to the selected “Fail Safe Response” mode. The system MUST be shut down and restarted for most critical alarms. Some functions may operate for a time after restart. The i5601E Display can show diagnostic warnings using the Network Nodes screen.

If the alarm is caused by the Throttle Actuator hitting the mechanical Wide Open Throttle (WOT) end stop - the alarm will go away when the throttle is pulled back. However, as with ALL Critical Alarms, the system must be serviced before further use. Non-Critical Alarms Intermittent flashing of both lights on either side of the control (five seconds flash, normal* for fifteen seconds, then repeating), indicates a Non-Critical Alarm. Acknowledge and reset by turning the control head OFF, then back ON. Continue to operate and have the system checked as soon as possible. * Normal - state the lights were in prior to the failure. Note:

On triple engine applications - the center engine alarms are displayed on the three switch panel. A jammed transmission may seem like a shift system problem. If having trouble with shifting, disconnect the transmission from the system and recheck the shift signals and the transmission separately. This is especially important on the BY2 Unlimited systems with Stern Drives. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 15:13