15 Troubleshooting Connector Problems In addition to the DeviceNet cables used for the CAN Bus the Yanmar Electronic Control systems use a number of Deutsch connectors. How to work on these connectors is shown in the Deutsch Connector section of this manual. Below is a list of things to watch out for if looking for a possible connector issue. Pin not fully seated and locked in the connector housing. The pin pushes back when mated and does not make a full contact. Check the pins are all fully inserted and locked in the housing. Improper tie down of wires going into housing. The wires should be straight out of the housing for several inches before any sharp bends.
Too tight a bend at the housing will break the watertight seal. The gasket between the orange pin cover and the housing is missing. This lets water into the connector. Replace gasket. Improper cable dress - While a properly assembled and dressed connector is watertight, good wiring practice is to put a drip loop in any cable that runs straight down and into a connector or housing. Power Reduction Mode BY2 Unlimited Series Engines An automatic protection mode called Power Reduction is included in the electronic control system to help protect the engine from major failure. On multi-engine boats, if one engine goes into power reduction, the engines will act independently.
Most power reduction situations on the BY2 Engine will cause a “P” Code to be set. Refer to the engine manual for the code descriptions. © 2011 Yanmar Marine International • Rev. 2.0 15:14 Yanmar Electronic Control Systems Technical Manual TABLE 6 - Control Head Alarms Problem Check Action No ignition power Fire system Remove fire system at CE41800 or CE42800 harness to test. See Accessory Section of this manual. i5601E Display operation problems Setup of features Use default reset feature to return to setup that matches operator’s manual (see page 3:23).
Trolling valve does not operate properly Settings Transmission must be at normal operating termperature and the boat in smooth water to do the settings.