Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

15 Troubleshooting 6LY3 Series Engines An automatic protection mode called Power Reduction is included in the electronic control system to help protect the engine from major failure. The Power Reduction mode will be activated if: A. The coolant temperature reaches or exceeds 110°C (230°F). B. The boost pressure reaches or exceeds 250 kPa (36 psi). C. An Engine speed sensors error occurs. D. The Rack Position sensor is out of range. E. The fuel injection timer shows an abnormal value. F. A Throttle Position error occurs. When the Power Reduction mode is active, the engine speed is limited to 1,800 rpm or less for items A through E.

Item F (Throttle Position error) will result in rpm returning to idle speed. [See “Redundant (Back-up) Throttle” description on page 3 of the 6LY3 operators manual - MANOPLYM01]. If the condition falls back below the threshold or the fault no longer exists, normal power will resume after engine shut- down and re-start. On multi-engine boats the following actions occur on Power Reduction:

Condition Engine with Power Reduction Action Sync OFF Either Engines operate independently Sync ON Master Slave slowly matches master Sync ON Slave Master normal, slave slows 6CX Series Engines An automatic protection mode called Power Reduction is included in the electronic control system to help protect the engine from major failure. The Power Reduction mode will be activated if: A. The coolant temperature is too high. B. The boost pressure is too high. C. The Fuel Rail pressure is too high. D. The Fuel Return Temperature is too high. E. The lube oil pressure is too low. When the Power Reduction mode is active, the engine speed is reduced to a safe operating RPM.

If the condition falls back below the threshold or the fault no longer exists, normal power will resume after engine shut-down and re-start. All of the above parameters have redundant sensors. If both sensors on a given parameter fail, the engine will stop. On multi-engine boats the following actions occur on Power Reduction: Sync OFF Either Engines operate independently Condition Engine with Power Reduction Action Sync ON Master Slave slowly matches master Sync ON Slave Master normal, slave slows © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 15:15