Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

15 Troubleshooting SY GEN III Series Engines An automatic protection mode called Power Reduction is included in the electronic control system to help protect the engine from major failure. The Power Reduction mode will be activated if the oil pressure drops below 2.3 bar (33 psi) for more than 5 seconds at an engine speed above 1000 rpm. In this mode the maximum power will be reduced to 70% of normal. On multi-engine boats the following actions occur on Power Reduction.

Condition Engine with Power Reduction Action Sync OFF Either Engines operate independently Sync ON Master Slave slowly matches master Sync ON Slave Master normal, slave slows Trolling calibration procedure For detailed trolling procedure documentation. please refer to the installation manual for the specific engine. Alternate trolling calibration procedures may be found in “Appendix C - Useful Information & Notes.” © 2011 Yanmar Marine International • Rev. 2.0 15:16 Yanmar Electronic Control Systems Technical Manual