Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

16 Accessory Information Automatic Fire Systems DANGER Fire Hazard Failure to assure that the fire system is working properly could create a fire hazard. CAUTION All wires must be properly terminated with Deutsch components. No crimps or butt connectors are to be used in this circuit. A poor connection or open circuit will render the engine inoperable. SY GEN III Cable CE41800 plugs into either end of the CE404XX Extension Harness. It supplies a three-pin Deutsch connector that has ignition power (pin A) and two lines that open the emergency stop line (pins B & C). These two wires are connected to the automatic fire system to a contact that opens in the event of a fire.

This will immediately shut down the engine. The ignition signal supplies 12 volts to the fire system when the ignition is turned on. The mating Deutsch housing is DT04-3P. The mating contact pin is 1060-16-0122. Wire per Automatic Fire System diagram. a B C Note: Once the CE41800 is installed, the engine will not run until the fire system is completely operational. 6LY3, 6CX Cable CE42800 plugs into either end of the CE404XX Extension Harness. It supplies a three-pin Deutsch connector that has ignition power (pin A) and two lines that open the emergency stop line (pins B & C). These two wires are connected to the automatic fire system to a contact that opens in the event of a fire.

This will immediately shut down the engine. The ignition signal supplies 12 volts to the fire system when the ignition is turned on. The mating Deutsch housing is DT04-3P. The mating contact pin is 1060-16-0122. Wire per Automatic Fire System diagram. a B C Note: Once the CE42800 is installed, the engine will not run until the fire system is completely operational. Note: Early 6LY3 engines sometimes use the CE41800 alarm harness. for information on this see Marine Service Advisory MSA06-022 © 2011 Yanmar Marine International • Rev. 2.0 16:4 Yanmar Electronic Control Systems Technical Manual