Appendix C useful information & Notes BY i5601E v4.01 alarm display issue (when used with Dual Engine BY1 Installation) Problem: In case of fault situation, generic alarm “check engine” is shown on tachometer and display. BY2 dual + i5601E v4.01 does show Port P-codes in Port screen and Stb P-codes in Starboard screen With Combination Twin BY1 + Unlimited system + i5601E display v4.01, it is not possible to see alarm codes in the i5601E Starboard screen. Short Conclusion: This is an (small) issue of the BY(1) ECU, which is already solved in the BY2 and BY-PIP ECU’s. This “issue” only appears in Dual BY1 installations, not single.
There are no software conflicts or system integrity failure that result from this “issue”. A software update to “repair” this issue in the current ECU is not and will not be available. Background: From the introduction of BY, alarm functionality was available as follows: Generic alarms via Tachometer and i5601E display. Examples: “Check engine”, “Hot engine”, etc. Troublecodes could be retrieved by separate handheld OBD-reader to be connected to a diagnostics connector (K-line) on the engine harness. It was not possible to read troublecodes by i5601E01 display v3.00. Above relates to BY engine ECU versions v3.10 and below and i5601E01 display version v3.00.
The engine ECU was in fact sending out NMEA troublecode messages, but the display was not programmed to show them. At the release of BY2 and BY-PIP engines, also the ECU was updated to v4.00 (this version applied only to BY2 and BY-PIP engines). Later, a software update for the i5601E display was released, version v4.01. With this update the Faultcodes can now be viewed when connecting to a BY engine: Two P-codes only It is not possible to scroll through codes if there are more than two codes. Functionality not same as LY/SY engines. This is an added functionality meant as extra aids for customers and dealers without OBD reader. Still for proper diagnosis, separate OBD-reader is required.
© 2011 Yanmar Marine International • Rev. 2.0 C:4 Yanmar Electronic Control Systems Technical Manual