Appendix C useful information & Notes Investigation: Several different combinations and versions were compared: Single and Dual Classic- or Unlimited- systems, i8130/i8140 interface boxes Port and Starboard Several versions of BY ECU’s (4&6BY, 4&6BY2 and BY-PIP) All versions of i5601E displays v4.01 (Single, Port, Stb, Center, Dual). At installation, the BY engine is setup to transmit Port or Starboard data over the CAN-line. This is done by inserting/removing the Fuse no7 in the fusebox. BY ECU v3.10 When set for Port, all engine data, generic alarms (“Check engine” etc.) and Faultcodes are transmitted as “Port” data.
When set for Stb, all engine data, generic alarms are transmitted as “starboard” data BUT the fault codes are ALSO transmitted as “PORT” data! This will result in: BY1 dual + i5601E01 v4.01 will show P-codes of Port and Starboard engine, alternating in Port screen. The starboard screen will show blanks . This can be verified by the following: Look only at the i5601E PORT display, BY diagnostic codes. If only Port engine ON: Codes of Port engine appear on Port screen. If no codes, Code count will show If only STB engine ON: Codes of STB engine appear also on Port screen. If no codes, Code count will show “0”.
If BOTH engines on, i5601E01 Port display will show “blinking” codes, alternating between Codes of Port and STB engines. All this time, the STB diagn screen will show blanks. As said, this issue does not exist with BY2 ECUs. Explanation: This is an issue related to the engine ECU of BY engines. The point is that this issue never showed up before simply because BY-engines were normally fitted with i5601E displays v3.0, where the P-codes weren’t visible. The issue had been solved in the BY2-engine series ECU, which was released after summer 2008. The i5601E display v4.01 became available after summer 2009.
If this new display is coupled with the current BY2 engines, all codes are presented properly (Port codes on Port display, Stb codes on Stb display). Conclusion of investigation: The described “display” issue is NOT due to any faulty component (ECU, interface box, display, wiring). It originates with the Engine ECU. The issue is very small and does not affect the control system and has no relation with other troubleshooting situations. The issue is already “solved” in the current BY2 and BY-PIP engine ECU. BY1 ECU can be updated to a BY2/BY-PIP ECU, but this can only be done together with the PI-Program.
The “display” issue cannot be remedied, therefore an update for this BY1 engine ECU will not be made for this purpose. Please see “How to handle the current situation.” The recommended way would be to use a different display i5601E01ED (so called Dual or Twin display) © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual C:5