Appendix C useful information & Notes Impact on market: The majority of boats will be: BY1 + i5601E v3.00 BY-PIP & BY2 + i5601E v3.00 BY-PIP & BY2 + i5601E v4.01 Existing boats normally don’t upgrade display from v3.00 -> v4.01 But even then, no problem occurs with single BY1 and i5601E v4.01. Majority of issues will be if dealers will use this v4.01 display as tool on BY1-boats without display, for example for adjusting low idle rpm. How to handle the current situation: If the customer does want to use the display for diagnostic purpose, the recommendation would be to: Set the display for Port, and turn one engine off and other ON, to view proper data from the “ON” engine.
OR, use an i5601E01ED (Dual display). Then diagn. troublecode screen has button “select engine” which makes it easy to view Port or Stb data. (much easier than changing the engine display in the factory settings menu). But then, so judge properly, only turn the engine ON from which you want to see codes... Refer to screen shot below and on next page. Data of two engines in one screen (i5601ED Dual Display). © 2011 Yanmar Marine International • Rev. 2.0 C:6 Yanmar Electronic Control Systems Technical Manual