Appendix C useful information & Notes Trolling calibration procedure SY GEN III Required components: ZF trolling valve kit: CP67601 - Trolling Switch CUKTSYSE - Interface i8355P version 1.01 CP67601: Trolling Switch (optional) Note: The trolling switch #CP67601 should be installed close to the helmet control because of short wiring and practical use. If the boat has multiple control heads, only 1 switch is required. Then we recommend installing the switch outside. A switch can be added to every control head if required. The 3 cables from switch connects to dual CH directly or to the “black box” of the single control head, with almost the same colours.
Calibration procedure of ZF trolling system on SY Gen III: Turn on engine control system by key or switch Hold the right button on the display until the picture changes to the Main Menu Scroll down to the factory settings, click the right arrow Enter code “3124” Choose “System Select.” Go into “Detect System: Select “MAN” (because system does not always recognize Trolling option) Go to Trolling: Select “Y” Go back to “Detect System:
Select “AUTO” Return to Factory Setting menu Set the engine type to “Single” (in case of single engine installation) Go down to the Troll valve setup, Click the right arrow Set “T RPM engage” in 800 or higher (Minimum 100RPM higher than idle speed!) Go down to “T Type,” select “ZF-ET” Return to Main Menu Go down to the “Calibration,” click the right arrow Go down go Trolling menu, Set “Troll mode” to “Full” Set Min prop. RPM from 15% to 19% (adjusted for each boat); (1x sample of Twin SY-Gen-I +ZF boat) Set Max prop.
RPM from 22% to 24% (adjusted for each boat); (1x sample of Twin SY-Gen-I +ZF boat) The active control head lever(s) must be in Neutral before Trolling can be switched on Check that Troll appears on display by “Troll” or “T” when troll button is activated and LED-button lights. When trolling is on, “T” will appear in the “ENG data” screen and ENG tacho display (button No.4) Test the system (outside of harbour): o Warm up engine and gear o Record Load% at Neutral. (Approx 2~10% at 0knots) o Record Load% (and GPS speed) at idle rpm (Approx 3~20% at 4~8knots) o Use this values to fine-tune settings Min prop. RPM % and Max prop. RPM % o Finetuning engaging trolling (min prop rpm):
Move control lever to Forward Idle, press troll button; Prop rpm should be zero (0), and load% same as in Neutral. If prop already turning, decrease Min prop rpm.% Move lever a little bit forward, now prop should start turning. If not turning, increase Min prop rpm.% © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual C:9