Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

Appendix C useful information & Notes o Finetuning end of troll function (max prop rpm) Move control lever to Full Forward, now gear should be FULL engaged (no troll), and GPS speed and load% same as in Idle no troll Move lever a little bit back, this should max troll. If prop is turning to slow, increase Max prop. RPM%. If prop speed, GPS speed, load% are same as in Idle no troll, decrease Max prop. RPM%. until you start to notice a difference in prop speed, GPS speed, load%.

Set Troll mode to “Split” (If required) Insert the lever travel of 60% or 80% (we recommend 80%) Set max throttle at 40% or 20% Go down to the valve cal., Click the right arrow Press “Yes” on “save settings” Push back until you get to the normal view 6LY3 with Kanzaki E-Type trolling valve on KMH61 Required components: • 777524-04711 or KIT-KMH61A-00028 Trolling Valve Kit • CP67601 Trolling Switch • CUKTLYSE Interface i8325P version 2.05 or 2.09 • Depending installation: Battery isolator (local supply) Note: The trolling switch #CP67601 should be installed close to the helmet control because of short wiring and practical use. If the boat has multiple control heads, only 1 switch is required.

Then we recommend installing the switch outside. A switch can be added to every control head if required. The 3 cables from switch connects to dual CH directly or to the “black box” of the single control head, with almost the same colours. Calibration procedure Kanzaki E-type trolling on KMH61 gearbox: • Turn on engine control system by key or switch • Hold the right button on the display until the picture changes to the Main Menu • Go down to the factory settings, click the right arrow • Enter code “3124” (press button no. 1 three times, etc), press enter. • Go into System Select. • Go into Detect System:

Select “MAN” (because system does not always recognize Trolling option) • Go into Trolling: Select “Y” • Go into Detect System: Select “AUTO”. • Go back to Factory Setting menu. • Set the engine type to “Single” (in case of single engine installation) • Go down to the “Troll valve setup,” Click the right arrow • Set “T RPM” engage in 800 or higher (Minimum 100RPM higher than idle speed!) • Go down to “T Type,” select “KZ-ET” • Return to Main Menu • Go down to the “Calibration,” click the right arrow • Go into the Trolling menu, Set “Troll mode” to “Full” • Set Min prop. RPM from 50% to 63% (adjusted for each boat) • Set Max prop.

RPM from 60% to 69% (adjusted for each boat) • The active control head lever(s) must be in Neutral before Trolling can be switched on • Check that Troll appears on display by “Troll” or “T” when troll button is activated and LED-button lights. © 2011 Yanmar Marine International • Rev. 2.0 C:10 Yanmar Electronic Control Systems Technical Manual