Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

Appendix C useful information & Notes • When trolling is on, “T” will appear in the “ENG data” screen and ENG tacho display (button No.4) • Test the system (outside of harbour): o Warm up engine and gear o Record Load% at Neutral. (Approx 2~10% at 0knots) o Record Load% (and GPS speed) at idle rpm (Approx 3~20% at 4~8knots) o Use this values to fine-tune settings Min prop. RPM % and Max prop. RPM % o Finetuning engaging trolling (min prop rpm): Move control lever to Forward Idle, press troll button; Prop rpm should be zero (0), and load% same as in Neutral. If prop already turning, decrease Min prop rpm.% Move lever a little bit forward, now prop should start turning.

If not turning, increase Min prop rpm.% o Finetuning end of troll function (max prop rpm) Move control lever to Full Forward, now gear should be FULL engaged (no troll), and GPS speed and load% same as in Idle no troll Move lever a little bit back, this should max troll. If prop is turning to slow, increase Max prop. RPM%. If prop speed, GPS speed, load% are same as in Idle no troll, decrease Max prop. RPM%. until you start to notice a difference in prop speed, GPS speed, load%.

• Set “Troll mode” to “Split” (If required) • Insert the lever travel of 60% or 80% (we recommend 80%) • Set max throttle at 40% or 20% • Scroll down to the “Valve cal.”, Click the right arrow • Press “Yes” on “Save Settings” • Push back until you get to the normal view © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual C:11