3 i5601E Digital Display 6LY3, 6CX 6LY3, 6CX Expanded Menu Performs the function indicated by a pop-up menu, if present. With no pop-up menu showing, briefly press to display the “Lighting & Contrast” menu. With no pop-up menu showing, press and HOLD to display the MAIN MENU. ALARMs / DIAGs MAIN MENU Diag Codes Alarms MONITOR SETTINGS ALARMs / DIAGs Network Status USER SETTINGS CALIBRATION Network Nodes Reset Maint.
Time Docking Mode FACTORY SETTINGS MONITOR SETTINGS Fwd Throt Curv 5 Password Protected Rev Throt Curv 1 Split Range 25% Prog Shift Dly 7.2 Station Protect N TROLLING Troll Mode SPLIT software revision 4.01 Lever 60% Max Throttle 40% CALIBRATION USER SETTINGS VALVE CAL TROLLING TRIM TRIM SHIFT ACTUATOR SNDR Type (see NOTE 1) SNDR Cal FACTORY SETTINGS SHIFT ACTUATOR Lead Eng: Port ** Does not appear unless trolling option is on *** Not shown unless troll mode is split * Does not appear on single engine setups Eng Display: PORT To FWD Gear: PUSH **** Docking Mode only shows on triple engine applications. Software revision 2.05 or higher Enter Idle RPM 700 Sync: Cruise FWD Stroke:
20 REV Stroke: 25 Send to Unit ***** 650 for the 6CX Engine T Engage Dly 0.2 TROLL Valve Setup SETUP TROLL VALVE Set System Defaults Fixed Shift Dly: 0.2 T RPM ENGAGE 850 T Type ZF SYSTEM SELECT SYSTEM SELECT Buttons Sys Detect Auto Down Arrow moves menu selection down Engine UNL Engine Count 1 Up Arrow moves menu selection up Trolling N Shift Acutator N Right Arrow acts on current menu item Back Moves back to previous menu SHIFT ACTUATOR only present for Stern Drives Note 1: Sender types: SM STK (Smart Stick) - used with Yanmar Outdrives, and RES (Resistive) - used with Mercury Outdrives © 2011 Yanmar Marine International • Rev.
2.0 3:12 Yanmar Electronic Control Systems Technical Manual HOT KEYS LOCK Units Menu Language Menu Tach Range 0-4000 SPEED Depth Offset Default Monitor Beeper ON About