3 i5601E Digital Display Factory Settings T Valve Setup If the “T RPM Engage” value is set below the Idle RPM, trolling will never be engaged. If the value is set just above the Idle RPM, On/Off hunting of the troll function can occur. The value must be set at 800 or 1000 RPMs. The T value may be set between 400 and 1000 RPMs at 50 RPM increments. Fixed Shift Delay See page 3:28 for information. Set System Defaults This resets all settings for the entire system back to the factory default settings. This includes any parameters in the Calibration menu. After a “Set System Defaults” command, it might be necessary to recalibrate the system. Note:
For all defaults to occur, a “power down” and “power up” is of the system is required. To reset ONLY the i5601E monitor, see the “Default Monitor Command” on page 3:23. System Select System Detect Auto* or Manual (There is NO auto select for the 6CX. It must be selected in the “manual” mode). Engine When System Detect is on “Manual,” use to select engine type. Engine Count Number of engines on the system. Trolling Yes or No* Shift Actuator Yes or No* * Default Settings © 2011 Yanmar Marine International • Rev. 2.0 3:44 Yanmar Electronic Control Systems Technical Manual