3 i5601E Digital Display Factory Settings Quad Screen Parameters The following pages show the Quad Screen Parameters for the BY2 Unlimited, SY GEN III and 6LY3, 6CX engines. These data choices can be placed in any box of a quad screen. The default screen headings are noted in bold .
BY2 Unlimited Series Engines Screen Heading Function Typical Data Source Battery Battery Voltage Engine Bearing Bearing to Waypoint GPS COG Course Over Ground GPS Coolant Engine Coolant Temperature Engine Depth Depth of the water Sonar Fuel Rate Fuel level if single engine Sender Fuel Tank 1 Fuel level in Tank 1 Sender Fuel Tank 2 Fuel level in Tank 2 Sender Fuel Tank 3 Fuel level in Tank 3 Sender Fuel Tank 4 Fuel level in Tank 4 Sender Gear Indicates the selected gear Engine Heading Current vessel heading Compass Hours Actual Engine Hours Engine Load Percent load on engine Engine Network Network voltage Engine Oil Pressure Engine Oil Pressure Engine Oil Temperature Engine Oil Temperature Engine RPM Engine Revolutions Per Minute Engine Rudder Rudder Angle Sender Sea Temp Sea Water Temperature Sender SOG Speed Over Ground GPS Speed (SOW) Speed through the water Sender Tab Port Position of the Port Trim Tab Sender Tab Stbd Position of the Starboard Trim Tab Sender Trim Port Port Engine Trim Sender Trim Stbd Starboard Engine Trim Sender Throttle The percent of throttle currently selected Engine Torque The percent torque the engine is developing Engine Turbo The amount of turbo boost pressure Engine Waste The amount of waste in the holding tank Sender Water The amount of water in the water tank Sender WP Dist The distance to the selected waypoint GPS XTE graph The cross track error from a best source GPS XTE value The cross track error from a best source GPS For additional details see the respective operations manuals.
© 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 3:45