SEBU8598 33 Engine Starting Before Starting Engine Engine Starting Do not start the engine or move any of the controls if there is a DO NOT OPERATE warning tag or similar warning tag attached to the start switch or to the controls. i02109067 Before Starting Engine Ensure that the areas around the rotating parts are clear. SMCS Code: 1000; 1400; 1450 Perform the required daily maintenance and other periodic maintenance before the engine is started. Inspect the engine compartment. This inspection can help prevent major repairs at a later date. Refer to the Operation and Maintenance Manual, “Maintenance Interval Schedule” for more information. All of the guards must be put in place.
Check for damaged guards or for missing guards. Repair any damaged guards. Replace damaged guards and/ or missing guards. Disconnect any battery chargers that are not protected against the high current drain that is created when the electric starting motor (if equipped) is engaged. Check electrical cables and check the battery for poor connections and for corrosion. For the maximum service life of the engine, make a thorough inspection before the engine is started. Look for the following items: oil leaks, coolant leaks, loose bolts and trash buildup. Remove trash buildup and arrange for repairs, as needed. Reset all of the shutoffs or alarm components.
Inspect the aftercooler for loose connections and for debris buildup. Check the engine lubrication oil level. Maintain the oil level between the ADD mark and the FULL mark on the oil level gauge. Inspect the cooling system hoses for cracks and for loose clamps. Check the coolant level. Observe the coolant level in the coolant recovery tank (if equipped). Maintain the coolant level to the FULL mark on the coolant recovery tank. Inspect the alternator and accessory drive belts for cracks, breaks, and other damage. Inspect the wiring for loose connections and for worn wires or frayed wires.
If the engine is not equipped with a coolant recovery tank maintain the coolant level within 13 mm (0.5 inch) of the bottom of the filler pipe. If the engine is equipped with a sight glass, maintain the coolant level in the sight glass. Check the fuel supply. Drain water from the water separator (if equipped). Open the fuel supply valve. NOTICE All valves in the fuel return line must be open before and during engine operation to help prevent high fuel pressure. High fuel pressure may cause filter housing failure or other damage. Observe the air cleaner service indicator (if equipped).
Service the air cleaner when the yellow diaphragm enters the red zone, or when the red piston locks in the visible position. Ensure that any driven equipment has been disengaged. Minimize electrical loads or remove any electrical loads. If the engine has not been started for several weeks, fuel may have drained from the fuel system. Air may have entered the filter housing. Also, when fuel filters have been changed, some air pockets will be trapped in the engine. In these instances, prime the fuel system. Refer to the Operation and Maintenance Manual, “Fuel System - Prime” for more information on priming the fuel system. i04132731 Cold Weather Starting SMCS Code:
1000; 1250; 1450; 1453; 1456; 1900 Startability will be improved at temperatures below 10°C (50°F) from the use of a cylinder block coolant heater or from other means that are used to heat the crankcase oil. Some engine applications use a jacket water heater to improve startability. Use of a jacket water heater will help reduce white smoke and misfire during start-up in cold weather. Engine exhaust contains products of combustion which may be harmful to your health. Always start and operate the engine in a well ventilated area and, if in an enclosed area, vent the exhaust to the outside.