80 SEBU8598 Maintenance Recommendations Engine Storage Procedure - Check 5. Install the oil filter. Tighten the oil filter until the oil filter gasket contacts the base. Tighten the oil filter by hand according to the instructions that are shown on the oil filter. Do not overtighten the oil filter. Mileage Operating hours Fuel consumption Fill the Engine Crankcase If an engine is out of operation and if use of the engine is not planned, special precautions should be made. If the engine will be stored for more than three months, a complete protection procedure is recommended.
For more detailed information on engine storage, see Special Instruction, SEHS9031, “Storage Procedure For Caterpillar Products”. 1. Remove the oil filler cap. Fill the crankcase with the proper amount of oil. Refer to the Operation and Maintenance Manual, “Fluid Recommendations” topic (Maintenance Section) for more information. If the engine will not be started for several weeks, the lubricating oil will drain from the cylinder walls and from the piston rings. Rust can form on the cylinder liner surface. Rust on the cylinder liner surface will cause increased engine wear and a reduction in engine service life.
Caterpillar recommends the use of volatile corrosion inhibitor (VCI) oil in order to prevent internal engine damage due to moisture during storage. These inhibitors in the VCI oil act by evaporating inside the engine. The inhibitors then condense over the inside surfaces of the engine. The evaporation process and the condensing process offers full protection to surfaces that cannot be reached with preservatives. 0.9 L (1.0 qt) of 4C-6792 VCI oil will treat 28.4 L (30.0 qt) of engine oil. This will give a 3 percent concentration of VCI oil. The engine must be completely sealed when the engine is stored in order for the VCI oil to function properly.
The VCI oil is easily cleaned from the engine when you remove the engine from storage. The volatile vapors are removed by simply running the engine to operating temperature. A mineral oil base is left behind after the volatile vapors are removed. NOTICE If equipped with an auxiliary oil filter or system, extra oil must be added when filling the crankcase. Follow the OEM or filter manufacturer's recommendations. If the extra oil is not added, the engine may starve for oil. NOTICE To help prevent crankshaft or bearing damage, crank engine to fill all filters before starting. Do not crank en- gine for more than 30 seconds. 2. Start the engine and run the engine at LOW IDLE for 2 minutes.
Perform this procedure in order to ensure that the lubrication system has oil and that the oil filters are filled. Inspect the oil filter for oil leaks. 3. Stop the engine and allow the oil to drain back to the sump for a minimum of 10 minutes. i03964791 Engine Valve Lash - Check 4. Remove the oil level gauge in order to check the oil level. Maintain the oil level between the ADD and FULL marks on the ENGINE STOPPED side of the oil level gauge. SMCS Code: 1105-535 Note: Procedures for adjusting the valve lash can be found in Systems Operation/Testing and Adjusting, “Valve Lash Adjustment”. Consult your Cat dealer for assistance. i01458399 Engine Storage Procedure - Check SMCS Code:
1000-535 Ensure that the engine cannot be started while this maintenance is being performed. To help pre- vent possible injury, do not use the starting motor to turn the flywheel. The oil change interval may be extended to 12 months for a vehicle that is operated seasonally and placed in storage for the remainder of the year by using the required storage procedures and the required start-up procedures. This extension is permitted if the following categories for oil change intervals in the Operation and Maintenance Manual, “Maintenance Interval Schedule” have not been reached: Hot engine components can cause burns.
Allow additional time for the engine to cool before meas- uring/adjusting valve lash clearance.