SEBU8598 79 Maintenance Recommendations Engine Oil and Filter - Change (Table 11, contd) (1) Refer to Special Publication, PEHJ0192, “Optimizing Oil Change Intervals” for further information.. Illustration 59 g00103713 Typical filter mounting base and filter gasket Drain the Engine Oil 1. Remove the oil filter with a 185-3630 Strap Wrench. After the engine has been run at the normal operating temperature, stop the engine. Attach a DO NOT OPERATE or a similar warning tag to the ignition keyswitch before the engine is serviced. 2. Cut the oil filter open with a 175-7546 Oil Filter Cutter Gp. Break apart the pleats and inspect the oil filter for metal debris.
An excessive amount of metal debris in the oil filter may indicate early wear or a pending failure. NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. Use a magnet to differentiate between the ferrous metals and the nonferrous metals that are found in the oil filter element. Ferrous metals may indicate wear on the steel and cast iron parts of the engine.
Nonferrous metals may indicate wear on the aluminum parts, brass parts, or bronze parts of the engine. Parts that may be affected include the following items: main bearings, rod bearings, turbocharger bearings and cylinder heads. Refer to Special Publication, NENG2500, “Cat Dealer Service Tool Catalog” or refer to Special Publication, PECJ0003, “Cat Shop Supplies and Tools Catalog” for tools and supplies suitable to collect and contain fluids on Cat products. Due to normal wear and friction, small amounts of debris may be found in the oil filter. Consult your Cat dealer in order to arrange for a further analysis if an excessive amount of debris is found in the oil filter.
Dispose of all fluids according to local regulations and mandates. 1. Remove the oil drain plug in order to allow the oil to drain. 3. Clean the sealing surface of the filter mounting base. Ensure that all of the old oil filter gasket is removed. 2. After the oil has drained, the oil drain plug should be cleaned and installed. 4. Apply clean engine oil to the new oil filter gasket. Replace the Oil Filter NOTICE Caterpillar oil filters are built to Caterpillar specifica- tions.
Use of an oil filter not recommended by Cater- pillar could result in severe engine damage to the engine bearings, crankshaft, etc., as a result of the larger waste particles from unfiltered oil entering the engine lubricating system. Only use oil filters recom- mended by Caterpillar . NOTICE Do not fill the oil filters with oil before installing them. This oil would not be filtered and could be contami- nated. Contaminated oil can cause accelerated wear to engine components.
Cat DEO-ULS Preferred 500 hr 250 hr Oil meeting the requirements of the Cat ECF-3 Specifica- tion or the API CJ-4 classification 8 minimum TBN Preferred 500 hr 250 hr Oil meeting the requirements of the ACEA C9/E6 Specification TBN below 10.4 500 hr 250 hr