Caterpillar — Caterpillar C15 and C18 Engine Operation and Maintenance Manual

82 SEBU8598 Maintenance Recommendations Fuel System Primary Filter (Water Separator) Element - Replace i05354209 Fuel System Primary Filter (Water Separator) Element - Replace NOTICE Do not fill fuel filters with fuel before installing them. The fuel will not be filtered and could be contaminated. Contaminated fuel will cause accel- erated wear to fuel system parts. The fuel system should be primed prior to starting the engine. SMCS Code: 1260-510-FQ; 1263-510-FQ Water in the fuel can cause the engine to run rough. Water in the fuel may cause an electronic unit injector to fail.

If the fuel has been contaminated with water, the element should be changed before the regularly scheduled interval. 1. Close the main fuel supply valve. The primary filter/water separator also provides filtration in order to help extend the life of the secondary fuel filter. The element should be changed regularly. If a vacuum gauge is installed, the primary filter/water separator should be changed at 50 to 70 kPa (15 to 20 inches Hg). Replace the Element Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.

Illustration 61 g01453091 (1) Element (2) Bowl (3) Drain 2. Remove element (1) from the element mounting base while bowl (2) is attached. NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. 3. Dispose of the contents of the filter. Remove bowl (2) from element (1). The bowl is reusable. Do not discard the bowl. Dispose of the used element. 4. Remove the O-ring from the gland of the bowl. Clean the following components:

Refer to Special Publication, NENG2500, “Dealer Service Tool Catalog” for tools and supplies suitable to collect and contain fluids on Cat products. Bowl Dispose of all fluids according to local regulations and mandates. O-ring Mounting base Inspect the O-ring for damage and for deterioration. Replace the O-ring, if necessary. NOTICE Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over discon- nected fuel system component. 5. Lubricate the O-ring with clean diesel fuel. 6. Install bowl (2) on a new element. Tighten the bowl by hand. Do not use tools in order to tighten the bowl. 7.

Lubricate the top seal of element (1) with clean diesel fuel. Install the new element on the mounting base. Tighten the element by hand.