Caterpillar — Caterpillar C15 and C18 Engine Operation and Maintenance Manual

SEBU8598 83 Maintenance Recommendations Fuel System Secondary Filter - Replace NOTICE The water separator is under suction during normal engine operation. Ensure that the vent plug is tight- ened securely to help prevent air from entering the fuel system. 1. Stop the engine. Turn the ignition switch to the OFF position or disconnect the battery. Refer to this Operation and Maintenance Manual, “Battery or Battery Cable - Disconnect” for more information. Shut off the fuel supply valve (if equipped). 2. It may be necessary to relieve residual fuel pressure from the fuel system before the fuel filters are removed. Wait from 1 minute to 5 minutes until the fuel pressure has lowered.

Use a suitable container in order to catch any fuel that may spill. 8. Open the main fuel supply valve. 9. Start the engine and check for leaks. Run the engine for 1 minute. Stop the engine and check for leaks again. Detecting leaks is difficult while the engine is running. The primary filter/water separator is under suction. A leak will allow air to enter the fuel. The air in the fuel can cause low power due to aeration of the fuel. Ensure that the components are correctly installed to prevent air from entering the fuel system. 3. Remove the used fuel filters and discard the used fuel filters. 4. Apply clean diesel fuel to the new fuel filter o-rings.

NOTICE Do not fill the secondary fuel filter with fuel before in- stalling. The fuel would not be filtered and could be contaminated. Contaminated fuel will cause acceler- ated wear to fuel system parts. i04158105 Fuel System Secondary Filter - Replace SMCS Code: 1261-510-SE NOTICE In order to meet expected fuel system component life, 4 micron(c) absolute or less secondary fuel filtration is required for all Caterpillar Diesel Engines that are equipped with unit injected fuel systems. Note that all current Caterpillar Diesel Engines are factory equipped with Caterpillar Advanced Efficiency 4 mi- cron(c) absolute fuel filters.

Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. Caterpillar does not warrant the quality or perform- ance of non-Caterpillar fluids and filters. NOTICE Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over any dis- connected fuel system components. 5. Install the new fuel filters. Spin the fuel filters onto the fuel filter bases until the o-rings contact the bases.

Use the rotation index marks on the filters as a guide for proper tightening. Tighten the filters according to the instructions that are on the fuel filters. Do not overtighten the filters. NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. 6. Open the fuel supply valve. The engine will need to be purged of air. Refer to this Operation and Maintenance Manual, “Fuel System - Prime” for more information.

Refer to Special Publication, NENG2500, “Caterpillar Dealer Service Tool Catalog” or refer to Special Publi- cation, PECJ0003, “Caterpillar Shop Supplies and Tools Catalog” for tools and supplies suitable to col- lect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates.