86 SEBU8598 Maintenance Recommendations Grounding Stud - Inspect/Clean/Tighten i03965989 Grounding Stud - Inspect/ Clean/Tighten Note: Always use a board or cardboard when the engine components are checked for leaks. Leaking fluid that is under pressure can cause serious injury or possible death. Leaks that are the size of a pin hole are included. Refer to Operation and Maintenance Manual, “General Hazard Information” for more information. SMCS Code: 7423-040; 7423-070; 7423-079 Inspect the Hoses and the Clamps Inspect all hoses for leaks that are caused by the following conditions. Replace any hose which exhibits any of the following conditions.
Failure to replace a hose which exhibits any of the following conditions may result in a hazardous situation. Hoses which are cracked Hoses which are soft Outer covering that is chafed or cut Exposed wire that is used for reinforcement Illustration 64 g01376112 The grounding stud is located on the upper left corner of the engine control module. Outer covering that is ballooning locally Flexible part of the hose that is kinked or crushed Inspect the OEM harness for good connections. Inspect the condition of the OEM harness. Armoring that is embedded in the outer covering The grounding stud must have a wire ground to the battery. Tighten the grounding stud at every oil change.
Ground wires and straps should be combined at engine grounds. All grounds should be tight and free of corrosion. Hoses which exhibit signs of leakage which are not the result of loose couplings or clamps Inspect all clamps for the following conditions. Replace any clamp which exhibits signs of any of the following conditions. Clean the grounding stud and the terminals for the ground strap with a clean cloth. Cracking If the connections are corroded, clean the connections with a solution of baking soda and water. Looseness Damage Keep the grounding stud and the strap clean and coated with MPGM grease or petroleum jelly. Inspect all couplings for leaks.
Replace any coupling which exhibits signs of leaks. Each installation application can be different. The differences depend on the following factors: i05909284 Hoses and Clamps - Inspect/ Replace Type of hose Type of fitting material SMCS Code: 7554-040; 7554-510 Anticipated expansion and contraction of the hose Hoses and clamps must be inspected periodically and replaced at the recommended interval to ensure safe and continuous operation of the engine. Failure to replace a fuel hose at the recommended change interval may result in a hazardous situation. Take proper safety precautions before inspecting or replacing hoses and clamps.
Anticipated expansion and contraction of the fittings Due to extreme temperature changes, the hose will heat set. Heat setting causes hose clamps to loosen which can result in leaks. A constant torque hose clamp will help to prevent loose hose clamps.