SEBU8598 87 Maintenance Recommendations Hoses and Clamps - Inspect/Replace Replace hoses that are cracked or soft. Replace hoses that show signs of leakage. Replace hoses that show signs of damage. Replace hose clamps that are cracked or damaged. Tighten or replace hose clamps which are loose. 5. Drain the coolant from the cooling system to a level that is below the hose that is being replaced. Drain the coolant into a suitable clean container. The coolant can be reused. 6. Remove the hose clamps. Replace the Hoses and the Clamps NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting, and repair of the product.
Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. 8. Replace the old hose with a new hose. 7. Disconnect the old hose. 9. Install hose clamps which have been inspected or install new hose clamps. Refer to Specifications, SENR3130, “Torque Specifications”, “Hose Clamps” for information about selecting and installing the proper hose clamps. Refer to Special Publication, NENG2500, “Cat Dealer Service Tool Catalog” or refer to Special Publication, PECJ0003, “Cat Shop Supplies and Tools Catalog” for tools and supplies suitable to collect and contain fluids on Cat products. 10. Refill the cooling system.
11. Clean the filler cap for the cooling system. Inspect the gaskets on the filler cap. Replace the filler cap if the gaskets are damaged. Install the filler cap. Dispose of all fluids according to local regulations and mandates. 12. Start the engine. Inspect the cooling system for leaks. Cooling System Fuel System Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Personal injury can result from removing hoses or fittings in a pressure system.
Failure to relieve pressure can cause personal injury. Do not disconnect or remove hoses or fittings un- til all pressure in the system has been relieved. Personal injury can result from removing hoses or fittings in a pressure system. Failure to relieve pressure can cause personal injury. Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service in- structions may cause personal injury or death. Do not disconnect or remove hoses or fittings un- til all pressure in the system has been relieved. 1. Stop the engine. NOTICE Do not bend or strike high pressure lines.
Do not in- stall bent or damaged lines, tubes or hoses. Repair any loose or damaged fuel and oil lines, tubes and hoses. Leaks can cause fires. Inspect all lines, tubes and hoses carefully. Tighten all connections to the recommended torque. 2. Allow the engine to cool. 3. Before servicing a coolant hose, slowly loosen the filler cap for the cooling system in order to relieve any pressure. 4. Remove the filler cap for the cooling system.