(1) Fitting of electric control Fitting of electric control 1 1 侍 All single parts are to be checked for damage and replaced, if required. Ensure free travel of the moving parts in the valve block prior to installation. Pistons can be exchanged individually. Prior to the installation, oil single parts. 刮 With the concave side showing upwards, insert orifice (1) until contact is obtained. 7609ATM371 侍 See arrows for installation position. 刯 The opposite figure shows the following single parts : 1 Pressure reducing valve (1EA, piston and compr. spring) 2 Vibration damper (3EA, piston and compr. spring 3 Follow-on slide (3EA, piston and compr.
spring) 3 1 2 7609ATM372 到 Install the single parts according to figure TM372. 侍 Preload compression springs of the follow-on slides and preliminarily fix pistons by means of cylindrical pins 凱 5.0 mm (assembly aid), see arrows (S). S 7609ATM373 刱 Fit two adjusting screws. 2 Mount seal (1) and housing (2). Then position housing equally by means of adjusting screws until contact is obtained. 1 S S Adjusting screws 5870 204 036 7609ATM374 3-193