Kaiyi — Kaiyi Power Train System Technical Manual

制 Install the single parts according to figure TM378. 1 侍 Preload the compression springs of the follow-on slides and fasten the pistons preliminarily by means of cylindrical pins (S) 凱 5.0 mm (assembly aid), see arrows (S). S Install two adjusting screws. Adjusting screws M5 5870 204 036 7609ATM379 Assemble flat gasket (1) and housing cover. Then place the housing cover by means of adjusting screws equally until contact. 刷 Preload the pistons with Torx screws and remove the cyl. pins (assembly aid) again. 1 Then fasten the housing cover by means of Torx screws (1). 余 Tightening torque (M5/10.9 佴 30) :

0.56 kgf 余 m (4.06 lbf 余 ft ) Adjusting screws 5870 204 036 Reducer 5870 656 056 Socket spanner TX-27 5873 042 002 7609ATM380 券 Mount the pressure regulators with O-ring 13.5 Ч 2 (1) and fasten them by means of fixing plates and cap screws. 1 侍 Install the fixing plate with the neck showing downwards. Observe radial installation position of the pressure regulators, see figure. 余 Tightening torque (M5/8.8 佴 12) : 0.56 kgf 余 m (4.06 lbf 余 ft ) 7609ATM381 刹 Assemble the wiring harness (1) and connect the pressure regulators (6EA). 1 侍 See figure TM368 for installation position of pressure regulators.

侍 Pay attention to the installation position of the wiring harness, also see markings (figure TM009). 7609ATM382 3-195