Ν Heat the tapered roller bearing and insert it into the input pinion until contact is obtained. 7609AAX117 Setting of rolling torque of input pinion Setting of rolling torque of input pinion bearing bearing 0.15~0.41 0.15~0.41 kgf 余 m m (1.11~2.95 (1.11~2.95 lbf 余 ft ft ) (without shaft seal) (without shaft seal) Ξ Insert spacer (e.g. s = 8.18 mm ). ц According to our experience the necessary rolling torque is obtained when reusing the spacer which has been removed during disassembly (e.g. s = 8.18 mm ). A later check of the rolling torque, however, is absolutely necessary.
7609AAX118 Ο Insert the preassembled input pinion into the axle drive housing and insert the heated tapered roller bearing until contact is obtained. 7609AAX119 Π Press the protection plate onto the input flange (see arrow) until contact is obtained. ц Do not fit the shaft seal until the contact pattern has been checked (page 3-238). 7609AAX120 3-234