Kaiyi — Kaiyi Power Train System Technical Manual

Ρ Insert input flange and fix it by means of disk and slotted nut. 余 Tightening torque : 122 kgf 余 m (885 lbf 余 ft ) Slotted nut wrench 5870 401 139 Clamping device 5870 240 002 ц Preliminarily mount slotted nut without loctite. While tightening rotate the input pinion While tightening rotate the input pinion several times in both directions. several times in both directions. 7609AAX121 Check rolling torque (0.15~0.41 kgf 余 m ) without shaft seal). ц When installing new bearings try to achieve the upper value of the rolling torque.

In case of deviations from the In case of deviations from the necessary rolling torque correct with a necessary rolling torque correct with a corresponding spacer (AX118, page corresponding spacer (AX118, page 3-234) as specified below. 3-234) as specified below. Insufficient rolling torque Insufficient rolling torque 7609AAX122 install thinner spacer ring install thinner spacer ring Excessive rolling torque Excessive rolling torque install thicker spacer ring install thicker spacer ring Σ Grease O-rings (2EA, see arrows) and insert them into the annular grooves of the piston. ц Operation figure AX123 and AX124 is only necessary for hydraulic lock differential (option).

7609AAX123 Τ Insert piston (see arrow) into the bearing housing until contact is obtained. 7609AAX124 3-235