Wet front face (contact face bearing inner ring, arrow 1) and profile (teeth, arrow 2) in the output shaft with anti- corrosive agent. 7609AAX162 Align disk package centrally and radially. Then insert the planetary carrier by means of the lifting device into the teeth of the output shaft.
Rear axle (planetary carrier with 3 planetary gears) Inner extractor 5870 300 019 Eye bolt 5870 204 073 7609AAX163 Front axle (planetary carrier with 4 planetary gears) Inner extractor 5870 300 017 Eye nut 5870 204 076 Setting of gap width output shaft / Setting of gap width output shaft / planetary carrier planetary carrier Bring planetary carrier with measuring disk and three old locking screws, which were removed during disassembly, into contact position. 余 Tightening torque : 20.4 kgf 余 m (148 lbf 余 ft ) Measuring disk AA00 360 730 7609AAX164 Pivot output 180˚ and measure gap width from the output shaft to the planetary carrier (see also subsequent sketch). Gap width e.g. . . . . . . . .
. . . . . . . 0.21 mm Then remove the locking screws and the measuring disk again. 7609AAX165 3-247