侍# Some fault codes are not applied to this machine. 3-58 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 18 S.C. to battery voltage at customer specific function No. 1 (ride control) TCU detected a wrong voltage at the output pin, that looks like a S.C. to battery voltage  Cable is defective and is contacted to battery voltage  Customer specific function No. 1 device has an internal defect  Connector pin is contacted to battery voltage Customer specific 余 Check the cable from TCU to customer specific function No. 1 device 余 Check the connectors from customer specific function No.
1 to TCU 余 Check the resistance of customer specific function No. 1 device 19 O.C. at customer specific function No. 1 (ride control) TCU detected a wrong voltage at the output pin, that looks like a O.C. for this output pin  Cable is defective and has no connection to TCU  Customer specific function No. 1 device has an internal defect  Connector has no connection to TCU Customer specific 余 Check the cable from TCU to customer specific function No. 1 device 余 Check the connectors from customer specific function No. 1 device to TCU 余 Check the resistance of customer specific function No. 1 device 21 S.C. to battery voltage at clutch cut off input The measured voltage is too high:
 Cable is defective and is contacted to battery voltage ÂClutch cut off sensor has an internal defect ÂConnector pin is contacted to battery voltage Clutch cut off function is disabled OP mode : Normal 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the clutch cut off sensor 22 S.C. to ground or O.C. at clutch cut off input The measured voltage is too low: ÂCable is defective and is contacted to vehicle ground ÂCable has no connection to TCU ÂClutch cut off sensor has an internal defect ÂConnector pin is contacted to vehicle ground or is broken Clutch cut off function is disabled OP mode :
Normal 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the clutch cut off sensor 25 S.C. to battery voltage or O.C. at transmission sump temperature sensor input The measured voltage is too high: ÂCable is defective and is contacted to battery voltage ÂCable has no connection to TCU ÂTemperature sensor has an internal defect ÂConnector pin is contacted to battery voltage or is broken No reaction, TCU use default temperature OP mode : Normal 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the temperature sensor