Kaiyi — Kaiyi Power Train System Technical Manual

侍# Some fault codes are not applied to this machine. 3-59 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 26 S.C. to battery voltage or O.C. at transmission sump temperature sensor input The measured voltage is too low: ÂCable is defective and is contacted to vehicle ground ÂTemperature sensor has an internal defect ÂConnector pin is contacted to vehicle ground No reaction, TCU uses default temperature OP mode : Normal 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the temperature sensor 27 S.C. to battery voltage or O.C.

at retarder temperature sensor input The measured voltage is too high:  Cable is defective and is contacted to battery voltage  Cable has no connection to TCU ÂTemperature sensor has an internal defect ÂConnector pin is contacted to battery voltage or is broken No reaction, TCU uses default temperature OP mode : Normal 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the temperature sensor 28 S.C. to ground at retarder temperature sensor input The measured voltage is too low:

ÂCable is defective and is contacted to vehicle ground ÂTemperature sensor has an internal defect ÂConnector pin is contacted to vehicle ground No reaction, TCU uses default temperature OP mode : Normal 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the temperature sensor 31 S.C. to battery voltage or O.C. at engine speed input TCU measures a voltage higher than 7.00V at speed input pin  Cable is defective and is contacted to battery voltage  Cable has no connection to TCU ÂSpeed sensor has an internal defect ÂConnector pin is contacted to battery voltage or has no contact OP mode :

Substitute clutch control 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the speed sensor 32 S.C. to ground at engine speed input TCU measures a voltage less than 0.45V at speed input pin  Cable/connector is defective and is contacted to vehicle ground ÂSpeed sensor has an internal defect OP mode :

Substitute clutch control 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the speed sensor 33 Logical error at engine speed input TCU measures a engine speed over a threshold and the next moment the measured speed is zero  Cable/connector is defective and has bad contact  Speed sensor has an internal defect ÂSensor gap has the wrong size OP mode : Substitute clutch control 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the speed sensor 余 Check the sensor gap ö This fault is reset after power up of TCU