侍# Some fault codes are not applied to this machine. 3-61 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 3B S.C. to ground at output speed input TCU measures a voltage less than 1.00V at speed input pin  Cable/connector is defective and is contacted to vehicle ground ÂSpeed sensor has an internal defect Special mode for gear selection OP mode : Substitute clutch control If a failure is existing at turbine speed, TCU shifts to neutral OP mode :
Limp home 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the speed sensor 3C Logical error at output speed input TCU measures a turbine speed over a threshold and at the next moment the measured speed is zero  Cable/connector is defective and has bad contact ÂSpeed sensor has an internal defect ÂSensor gap has the wrong size Special mode for gear selection OP mode : Substitute clutch control If a failure is existing at turbine speed, TCU shifts to neutral OP mode :
Limp home 余 Check the cable from TCU to the sensor 余 Check the connectors 余 Check the speed sensor 余 Check the sensor gap ö This fault is reset after power up of TCU 3D Turbine speed zero doesn't fit to other speed signals - 余 Not used 3E Output speed zero doesn't fit to other speed signals If transmission is not neutral and the shifting has finished, TCU measures output speed zero and turbine speed or internal speed not equal to zero. Â Speed sensor has an internal defect ÂSensor gap has the wrong size Special mode for gear selection OP mode : Substitute clutch control If a failure is existing at turbine speed, TCU shifts to neutral OP mode :
Limp home 余 Check the sensor signal of output speed sensor 余 Check the sensor gap of output speed sensor 余 Check the cable from TCU to the sensor ö This fault is reset after power up of TCU 54 DCT1 timeout Timeout of CAN-message DCT1 from display computer  Interference on CAN-Bus  CAN wire/connector is broken  CAN wire/connector is defective and has contact to vehicle ground or battery voltage OP mode :
Normal 余 Check display computer 余 Check wire of CAN-Bus 余 Check cable to display computer 55 JSS timeout Timeout of CAN-message JSS from joystick steering controller  Interference on CAN-Bus ÂCAN wire/connector is broken ÂCAN wire/connector is defective and has contact to vehicle ground or battery voltage TCU shifts to neutral while joystick steering is active OP mode :
Normal 余 Check joystick steering controller 余 Check wire of CAN-Bus 余 Check cable to joystick steering controller 56 Engine CONF timeout Timeout of CAN-message engine CONF from engine controller ÂInterference on CAN-Bus  CAN wire/connector is broken  CAN wire/connector is defective and has contact to vehicle ground or battery voltage OP mode : Substitute clutch control 余 Check engine controller 余 Check wire of CAN-Bus 余 Check cable to engine controller