Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE l When loosening tension tension is not relieved by this procedure, please contact 1. Loosen lubricator 0 gradually to release the grease. 2. Turn lubricator 0 a maximum of one turn. 3. If the grease does not come out smoothly, move the ma- chine backwards and forwards a short distance. 4. Tighten lubricator 0. 5. To check that the correct tension has been achieved, move the machine backwards and forwards. 6. Check the track tension again, and if the tension is not correct, adjust it again. 24.2.4 ;;WE AND TIGHTEN TRACK SHOE If the machine is used with track shoe bolts 0 loose, they will break, so tighten any loose bolts immediately. 0 1.

Method for tightening (shoe bolt) First tighten to a tightening torque of 15 + 2 kgm, then check that the nut and shoe are in close contact with the link contact surface. 2. After checking, tighten a further 60” _+ IO”. l 1. Method for tightening (master link connecting bolt) First tighten to a tightening torque of 15 f 2 kgm, then check that the link contact surfaces are in close contact. 2. After checking, tighten a further 180” f IO”. Order for tightening Tighten the bolts in the order shown in the diagram on the right. 3-32