24. SERVICE PROCEDURE 24.2.3 CHECK TRACK TENSION The wear of pins and bushings on the undercarriage will vary with the working conditions and soil properties. It is thus necessary to continually inspect the track tension so as to maintain the standard tension. Carry out the check and adjustment under the same condi- tions as when operating (on jobsites where the track becomes clogged with mud, measure with the track clogged with mud). Inspection Stop the machine on level ground (stop with the trans- mission in FORWARD without applying the brake).
Then place a straight bar on the track shoes between the carrier roller and the idler as shown in the figure, and measure the clear- ance between the bar and the grouser at the midpoint. If the clearance is 20 - 30 mm, the tension is standard. If the track tension is not at the standard value, adjust it in 20-30mm the following manner. Adjustment A WARNING Grease inside the adjusting mechanism is under high pressure. Grease coming from lubricator 0 under press- ure can penetrate the body causing injury or death. For this reason, do not loosen lubricator 0 more than one turn. Do not loosen any part other than lubricator 0. Furthermore, do not bring your face in front of grease fitting 0.
If the track tension is not relieved by this procedure, please contact your Komatsu distributor. 0 1. When increasing tension Pump in grease through grease fitting @ with a grease pump. 2. To check that the correct tension has been achieved, move the machine backwards and forwards. 3. Check the track tension again, and if the tension is not correct, adjust it again. 4. Continue to pump in grease until S becomes 39 mm. If the tension is still loose, the pin and bushing are excessively worn, so they must be either turned or replaced. Please contact your Komatsu distributor. , 3-31