24. SERVICE PROCEDURE 24.2.8 ADJUST BRAKE PEDAL If the travel of the brake pedal increases, the brake lining may be worn out. Adjust brakes as follows. Adjustment Adjust both left and right brakes. 1. Remove the rear cover and inspection cover @ in this order. 2. Tighten adjustment nuts 0, 0 to torque of 4 kgm until the lining contacts the drum. Then, turn adjustment nuts 0, @ in reverse directions for 2.5 rotations. 3. Check the travel of the brake pedal, refering to “24.3 CHECK BEFORE STARTING”. The standard clearance drum should be 0.3 mm. between the brake lining and the Basically speaking, this brake band clearance, but tween the lining and drum right side, check as follows.
If there is a difference completes the adjustment of the to ensure that the clearance be- is the same on both the left and between the clearance of the left and right brakes, the brakes will pull to one side. 4. Open inspection cover @ under the operator’s seat. Lever 0 can be seen behind the oil level gauge tube. Hook the end of a steel tape measure on the end of lever @ at a position as close as possible to yoke 8. 5. Read the movement of the steel tape (lever 0) while the brake pedal is depressed fully. It is easy to read the movement of the lever if you watch edge 0 of the inspection cover. If the movement is 30 mm, it is normal.
If the movement is not 30 mm, adjust again with adjust- ment nut 0 on the left side. 3-36